English 
Deutsch 
Français 
Español 
OX70JWR – Articulation deluxe flexible, démontable avec corde
A releasable rubber joint for Optimist tiller extionsions. Easy to mount with an aluminium pin and a piece of heat shrinkable tubing. The rubber joint has a rope core that will avoid complete failure should the rubber tear.
Produits similaires
-
PLUS D'INFOSOX60B – Système de livarde Optimist avec poulie Harken et anneau de friction
Optimist Halyard system with Windesign low friction ring. This halyard system is used on all Optimax spars from 2017. The combination of Harken hook-in block, Dyneema spliced halyard line and Windesign low friction ring creates the most advanced halyard system on the market.
-
PLUS D'INFOSOX25 – Set d’accastillage pour gréement Optimax
As supplied with Optimax masts and Optimax spar sets.
1 x Harken ball bearing hook-in block
1 x Windesign 25 mm low friction ring
1 x Windesign wind indicator PRO
1 x Deck collar with mast sleeve
1 x Nylon sprit adjuster handle
2 x Nylon top pins
1 x Dyneema primary halyard line
1 x Technora / Dyneema secondary halyard line
5 x 2.2 mm tack lines
12 x 1.2 mm double lacing lines -
PLUS D'INFOSOX61CS – Bague d’étambrai basse friction avec collier, grise
The Optimax Optimist deck collar is made of Delrin to create minimal friction between the sleeve and the collar. The oval inner diameter allows the maximum fore/aft and minimum side play and the tapered inner diameter allows the mast to be raked. 4 countersunk mounting holes. Hole size in deck: 57 mm.
The mast sleeve is fitted around the mast at deck level and protects the mast from wearing. Optimist mast sleeve as supplied with Optimax spars.
Mounting the sleeve – you will notice the sleeve is slightly smaller than the mast. To mount the sleeve you should gently warm the sleeve with a hairdryer or paint stripper. You can easily slide the warm sleeve over the mast into position.
